In fact, the difficulty of cooling for many large-area factories is that the factory area is large and the workers in the workshop are relatively scattered. There are always large-area factories with a very complex environment and factors will increase the difficulty of solving the cooling problem. At this time, if Some of the traditional methods of air conditioning to cool down are too expensive.  Or choose fan with low cost, while it will not be able to achieve the improvement you want. So what should you do? Industrial air cooler is effective and cost-effective factory cooling solutions that can quickly cool down large-area factories

1. Environmentally friendly Evaporative air cooler post cooling: It uses the principle of water evaporation to cool down. It is an energy-saving and environmentally friendly water air cooler equipment without refrigerant, no compressor, and no copper pipes. The core component is cooling pad (multi-layer corrugated fiber laminated When the air conditioning unit is running, the clean and cool fresh cold air filtered and cooled by the air cooler will be transported through the air supply duct to each post that needs to be cooled, ensuring that each worker in the workshop has an air outlet that can blow to a temperature difference of 5-10 degrees from the outdoor temperature. It can ensure that the cooling effect can be maintained at the best state in places with people.

2. Fan-air cooler combination overall ventilation and cooling: The fan-air cooler combination is simply an overall ventilation and cooling system used in combination with an industrial large fan + industrial air cooler. The cooling principle is very simple. Through the industrial air cooler, it is an environmentally friendly air conditioner. It transports clean and cool air indoors, and then distributes the cool air evenly throughout the workshop through the three-dimensional breeze circulation system generated by the operation of large industrial fans. The advantage of this is that it saves a large amount of air duct materials for environmentally friendly air cooler fixed-point cooling. while saving money, part of the cooling effect will inevitably be lost. In fact, the fan-air cooler combination has only been launched in recent years and has been actually applied to some specific environmental cooling methods, because this solution is better than air cooler for fixed-point cooling. There are limitations. First of all, the height of the workshop must be higher than 4.5 meters, and there are no obstacles on the roof within a diameter of 7 meters. For example, frequent traffic, etc. will not work, so although this solution is effective, It also saves money, but it is not suitable for cooling in all large-area factories. Only some environments can use this money-saving solution to achieve the improvement effect of ventilation, cooling and air exchange.